Cisco test 11

 

Question 1:

Which is an example of a Layer 3 internetworking device that passes data

packets between networks?

A. router

B. hub

C. bridge

D. switch

 

Question 2:

What do bridges and switches use to make data forwarding decisions?

A. logical addresses

B. physical addresses

C. network addresses

D. IP addresses

 

Question 3:

Which of the following contains a unique network number that is used in routing?

A. MAC address

B. physical address

C. IP address

D. NIC card

 

Question 4:

Which protocol is used to dynamically assign IP addresses?

A. DHCP

B. ARP

C. proxy ARP

D. IGRP

 

Question 5:

Which protocol can find the MAC address of a computer given its IP address?

A. RARP

B. DHCP

C. ARP

D. Proxy RARP

 

Question 6:

When configuring a host computer, which of the following describes the router

interface that connects to the same network segment?

A. default interface

B. default gateway

C. default port

D. default subnet

 

Question 7:

Which is a network layer protocol that can be routed?

A. IP

B. ISP

C. NetBEUI

D. ARP

 

Question 8:

Which is an example of a routed protocol?

A. RIP

B. IPX/SPX

C. EIGRP

D. OSPF

 

Question 9:

What is the most common protocol used to transfer routing information between

routers located on the same network?

A. OSPF

B. RIP

C. IGRP

D. EIGRP

 

Question 10:

In a connectionless system, which of the following is correct?

A. The destination is not contacted before a packet is sent. .

B. The destination is contacted before a packet is sent.

C. A connectionless connection is established with the recipient before a packet is sent.

D. A non-connection is established between the sender and recipient before a packet is sent.

 

Question 11:

In a connection-oriented system, what happens before any user data is

transferred?

A. a connection is established with the recipient's local router

B. a connection is established between the sender and receiver

C. a connection is established with the sender's local router

D. the destination is not contacted before any actual data is sent

 

Question 12:

Connection-oriented network processes are often referred to as what?

A. packet switched

B. segment switched

C. circuit switched

D. network switched

 

Question 13:

IP relies upon which OSI layer protocol to determine whether packets have been

lost and request retransmission?

A. application

B. presentation

C. session

D. transport

 

Question 14:

The IP address for a router interface should be part of what?

A. the network attached to the interface

B. any network attached to the router

C. it does not matter

D. router interfaces never have IP addresses

 

Question 15:

Router ARP tables hold information from which of the following?

A. all Ethernet LANs

B. all networks connected to them

C. all networks in the Internet

D. MAC addresses only

 

Question 16:

What is described when a router acts as a default gateway, allowing a device on

one subnet to find the MAC address of a host on another subnet?

A. proxy ARP

B. proxy RARP

C. RARP

D. subnetting

 

Question 17:

When sending data to a host on a different network, the source host

encapsulates data so that it contains what destination address in the IP header?

A. IP address of the router

B. MAC address of the router

C. MAC address of the destination device

D. IP address of the destination host

 

Question 18:

What do routers use to exchange routing tables and share route information?

A. routed protocols

B. transport protocols

C. routing protocols

D. UDP protocols

 

Question 19:

What happens if a data packet reaches a router that is destined for a network

with which that router is not directly connected?

A. The router forwards the packet to all other routers.

B. The router returns the packet to the source device with no explanation.

C. The router forwards the packet to another router that most likely contains information about the destination.

D. The router returns the packet to the source device with the explanation that the destination was unreachable.

 

Question 20:

Which of the following is an example of an IGP (Interior Gateway Protocol)?

A. IPX

B. SPX

C. UDP

D. IGRP

 

Question 21:

Which type of routing protocol is RIP?

A. distance vector

B. link state

C. hybrid

D. spanning tree

 

Question 22:

What are the two proprietary routing protocols developed by Cisco?

A. RIP and OSPF

B. IGRP and EIGRP

C. IPX and SPX

D. TCP and IP

 

Question 23:

What is the correct term for when routes are learned automatically?

A. static routing

B. automatic routing

C. enhanced routing

D. dynamic routing

 

Question 24:

Why is a static route the preferred method for reaching stub networks?

A. static routing requires less overhead

B. static routing requires more overhead on the network

C. this allows routers to adjust to changes in the network

D. the routes are learned automatically

 

Question 25:

Which type of routing allows routers to adjust to changing network conditions?

A. static

B. dynamic

C. automatic

D. stub

Question 26:

Which describes the changes made to a packet's IP destination address, as

that packet is passed from router to router on it's way to the destination host?

A. The destination IP address changes each hop, to be the address of the next router.

B. The destination IP address changes anytime a router is sending the packet over a WAN.

C. The destination IP address will always be the address of the first router.

D. The destination IP address never changes.